[email protected]

AFNOR S235JR - Equivalent Materials

There are 21 equivalent materials for AFNOR S235JR Carbon Steel. See the equivalents for DIN, BS, JIS, EN, ISO, GOST, GB/T and UNS. EN 10025 S235JR VS S275JR carbon steel - BBN SteelEN 10025 S235JR and S275JR carbon steel are commonly used steel materials. From the steel grades themselves, we can also realize the strength of S275JR carbon steel is higher than that of EN 10025 S235JR steel. Below is for EN 10025 S235JR VS S275JR carbon steel. EN 10025 S235JR VS S275JR carbon steel in chemical composition:

EN10025 S235JR steel plate standard and specification

S235JR (+N) is a non-alloy structural steel. We have large quantities of S235JR in stock with thicknesses up to 200 mm. The minimum thickness is normally 5 mm. Plates are available up to 3.5m wide and 14m long. S235JR - OvakoMaterial data sheet Steel grade Last revised:Fri, 30 Oct 2020 08:16:54 GMT S235JR All General Information Soft structural steel easy to weld and bend. Variants suitability for hot dip zinc coating according the classification in Table 1 EN 10025-2:2004:Class 1:Si max 0,030% and Si + 2,5 P max 0,090%. Class 2:Si max 0,035%. S235JR - OvakoS235JR:C max 0,20 % for sizes over 40 mm. Only CEV required in standard. SS 1312:Not binding recommendation for Mn (0,4 - 0,7) % in standard.

S235JRG2 (EN ) - Worldwide equivalent grades

S235JR (1.0038(dubl)) , S235JRG2 (European old, EN ) - European (EU, EN) and wordwide Steel equivalent grades These comparison table is only intended as an indication of the closest khown equivalent grades. The source standarts should always be checked for the specific purpose for each material, in case of doubt Table of material properties for structural steel S235 Jan 01, 1993 · Design values of additional material mechanical properties for structural steel. According to EN1993-1-1 §3.2.6, the design values of the material properties and coefficients for structural steel are:Modulus of elasticity (Young's modulus):E = 210000 MPa. Shear modulus:G = E / [ 2 (1 + ) ] = 80769 MPa 81000 MPa.S235JR Non-alloy Quality Structural Steel - EN MaterialS in the letters of S235JR material grade represent structural designation, letters in material grade designation i.e. 235 represents yield strength i.e. 235 N/mm² minimally, the JR additionally confirms that the steel has been applied to testing at 27 Joules with longitudinal Chary V-Notch impact testing at standard room temperature.